[OP]
Member
Removed the rotary turned on my laser and am trying to laser flat acrylic. Job control acts like the rotary is still attached.
i removed the rotary from the setup before sending the file but it still shows up and won't let me put my design on the page.
i reinstalled and removed the rotary. always have laser in off position as i know not to unplug when the laser is on.
rebooted computer.
any ideas?????
sandcarving and sublimation.
Trotec Speedy 300/80 watt!
Contributor
Not sure if this is an issue with JC, but did you resize the work area so it's not based on a cylinder and pi?
========================================
ELEVEN - rotary cutter tool machines
FOUR - CO2 lasers
THREE- make that FOUR now- fiber lasers
ONE - vinyl cutter
CASmate, Corel, Gravostyle
Member
When you say you removed rotary from setup did you do following?
Go to OPTIONS/HARDWARE/ACCESSORIES/ and uncheck ROTARY box.
Trotec Speedy 300 - 60w, with Quatro CSA-626 fume extraction
Xenetech 1625 x2,
New Hermes TX pantograph, CG4 cutter grinder
Brady Globalmark2 label printer,
Assortment of custom tooling , shears & punches, heat bender.
Software: Xenetech XOT, Corel X3, Bartender label software
Posting Permissions
Reply With Quote