For several years I have used Kreg clamps on a portable 30"x30" shop made top. Made with two layers of 3/4" plywood. This worked ok but was terribly heavy to set up and take down. I wish my shop was large enough for a permanent clamp table setup. A few months ago I built an new assembly/storage table and incorporated the Kreg rails in the table edges. This has worked great. Most of the time I use the flat assembly table but can setup Kreg clamps and spacers in a couple minutes when needed. Keeping all the Kreg clamps and spacers in the top drawer under the top gives quick access. I saw the other thread about clamping face frames and thought I'd share a solution that has worked great for my shop.
DSC_2572.JPGr.jpgDSC_2571.JPGr.jpg