Ok...Chest of Drawers is done. On to something else?
Have a few Cherry boards..
IMG_1692 (640x480).jpg
4 are in the range of 13-14" long, and a shorty...mainly around a 1 x 6 size.
Went through this stack, smoothing the faces, and making a shaving or two..
IMG_1689 (640x480).jpg
Used the "new" Stanley No. 4 to plane things a bit..
IMG_1688 (640x480).jpg
Bench getting filled up...most of the boards cleaned up nicely...
IMG_1693 (640x480).jpg
But there was a couple bad spots..
IMG_1691 (640x480).jpg
Plane never had any trouble....
Plan ( Plan? Plan?) is to resaw these down, somewhere between 1/2" or 3/8" thick. Then see about a simple box build? Box joints? Maybe another fancy lid? Not sure how wide or long, or high. BTW: I can also add a bit of that Black Walnut, if needed....or...make a matching box in walnut?
Just a start up....stay tuned...