Page 2 of 2 FirstFirst 12
Results 16 to 20 of 20

Thread: Need advice on Tenon vs. Mortise

  1. 08-26-2017, 9:25 PM #16
    Fred Belknap's Avatar
    Fred Belknap
    Fred Belknap is offline Member
    Join Date
    Sep 2008
    Location
    Gassaway, WV
    Posts
    1,221
    The bottom of JKJ's bowl reminds me of a crop circle .
    Fred
    Reply With Quote Reply With Quote
  2. 08-27-2017, 8:33 AM #17
    John K Jordan's Avatar
    John K Jordan
    John K Jordan is offline Moderator
    Join Date
    Feb 2008
    Location
    E TN, near Knoxville
    Posts
    12,298
    Quote Originally Posted by Fred Belknap View Post
    The bottom of JKJ's bowl reminds me of a crop circle .
    The bottom of that platter was actually made by friendly alien termites visiting from area 50 (in the classified hills behind Oak Ridge) assisted by a secret group of fairy woodturners lured above ground by a trail of rosewoods bits.

    JKJ
    Reply With Quote Reply With Quote
  3. 08-30-2017, 7:12 PM #18
    Jon Kurtz
    Jon Kurtz is offline [OP] Member
    Join Date
    Apr 2017
    Posts
    29
    Follow up question??? If I were to get a larger chuck to turn 14" bowls, what size would you guys recommend?
    Reply With Quote Reply With Quote
  4. 08-31-2017, 1:21 PM #19
    Leo Van Der Loo's Avatar
    Leo Van Der Loo
    Leo Van Der Loo is offline Member
    Join Date
    Jul 2008
    Location
    Atikokan, Rainy River district, Ontario
    Posts
    3,540
    Quote Originally Posted by Jon Kurtz View Post
    Follow up question??? If I were to get a larger chuck to turn 14" bowls, what size would you guys recommend?
    The Oneway Talon chuck would do just fine, good and made to hold for up to 16” and I have used it for larger than that, of course you could get the Oneway Stronghold if you like, it is build for larger than that again, I’ve turned 32” bowls, and my Stronghold is the one for the very large turnings.
    Have fun and take care
    Reply With Quote Reply With Quote
  5. 08-31-2017, 1:27 PM #20
    John K Jordan's Avatar
    John K Jordan
    John K Jordan is offline Moderator
    Join Date
    Feb 2008
    Location
    E TN, near Knoxville
    Posts
    12,298
    Quote Originally Posted by Jon Kurtz View Post
    Follow up question??? If I were to get a larger chuck to turn 14" bowls, what size would you guys recommend?
    The Teknatool Supernova 2 will easily handle a 14" bowl.

    JKJ
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules