I had posted a few pics of my vacuum table a few months ago. I made a couple of minor mistakes when I built the vacuum plenum and I have found the jigs I have needed to build various parts take too long to setup. I decided to replace the base board and vacuum plenum with phenolic and correct my errors. I am trying to decide how to attached the vacuum plenum to the base board. With the UHMW table the only option was screws, but now I could use an adhesive to bond the plenum to the base board. My preference is to use an adhesive, but I am concerned about the difficulty milling off the plenum later to access the base board bolts should I need to. I am looking for suggestions.