I am finally setting up a wood shop and would like to see if anyone can share opinion/insight into dust collection. I will be the only person working in the shop 99% of the time. Therefore, I will only be using one tool at a time. I have purchased a Sawstop 3.0 ICS and hope to locate a used 8" jointer. The other significant dust, wood chip producer will be a small Dewalt 13" planer. I had settled on an Oneida V-system 3.0 hp. The local Woodcraft dealer has informed me that this system will not be sufficient and strongly recommends the Oneida Dust Gorilla 3.0 hp. This is considerably more expensive, approximately $600.00 additional. He compared the static pressure stats of both systems and as I said he feels the V-system wil not perform adequately. The shop is only 24'x24', so the runs will not be longer that 15' to 18'. Has anyone had experience with these systems. Any help is greatly appreciated. Thanks