Results 1 to 12 of 12

Thread: Question about fence for Rockwell/Delta 28-345 20" band saw

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Question about fence for Rockwell/Delta 28-345 20" band saw

    I have a Delta table saw fence that I need to cut down to fit my 24-1/4" Rockwell 28-3X5 band saw table. I can wing it, but I have read of this being done before. I believe the table saw tables are 27" so I could take the difference and go for it, but this fence cost more than I want to say. So anyone have some tried and true numbers they can share?

    Also, these are my guides,shown stacked for a half inch blade. I have a 1" wide 14 tpi that is going to require a few more, any leads on where these can be purchased? I picked up a big chunk of lignum vitea to make blocks out of, but have not had time yet. Main thing is to get the fence and miter going since I can at least use 1/2" blades as is. Already put nice new blue tires on instead of the original plastic ones and it tracks perfectly, worth every penny of the $250 it cost.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •