I have a Versalaser VL-200 30 Watt laser.
I was lasering some bricks, ended the job, everything ended correctly.
I then went to a previous job on the driver and the problem starts:
With the door open, everything works correctly, x and y and z moves as directed. Red dot shows as well.
When I close the door the fan on the tube stops and I hear a chattering noise in the laser interior. The red light to the top left of the power button flashes.
If I unplug the tube, all goes well.
I checked the power supply in all cases and it reads 48VDC.
Does this sound like a bad tube?
Any help will be appreciated.... I only have 1 more brick Ughh.
Thanks,
Chris