It's been about 3 years since I first posted a carving and I just finished this one. I've had this piece of basswood around for a while and decided to put it to use (a prototype for a door panel.) This is the final sketch I made to visualize the flower.
flower3.jpg
After transferring it to the basswood, I started removing the background to give the flower some depth to work with. I roughed out the leaves, stem and blossom area. I worked on the leaves and stem first and then went to the blossom. After the basic form of the blossom was finished, I started on the petals.
RoughoutBlossom.jpgRoughoutPetals1.jpg
Here you can see the work on the petals:
RoughoutLand.jpgRoughoutAll.jpg
The whole carving was given a once over with the chisels and cleaned up. Some extra work was done on the petals and the button in the blossom.
Ready2Stain.jpg
Then the stain and finish with danish oil.
Complete.jpgBlossom.jpg
Thanks for looking and as usual, thanks for any critiques - can't progress without educational input!