Hi,
I am just finishing up a dust collection system for my small basement shop. I have the infamous HF 2HP (questionable) collector with 5" HVAC main lines running to several of the bigger tools (table saw, planer) and then a few "shared" 5" HVAC lines. I plan on using blast gates at each tool.
I was going to have some short pieces of 4" hose to connect the tool to the HVAC ducts so I could move them around a little if needed. Rather than buy a bunch of 10' sections, I'd like to get a 20-50' roll of the stuff and cut it down. I'm assuming this stuff cuts well with a pair of scissors and a wire cutter for the spine?