Search:

Hi Alexandra,

Have you had any success with your dovetail jig?
I just purchased the Leigh Super 12 jig and it is a real learning experience.
any tips and or tricks you could provide?

Aaron

Sounds like your system works well for you. What brand and model of dc do you have? Do you know the size of the impeller?

Thank you Ron. So you say both use up a lot of the static pressure, leaving little for the ducting? Are you not getting much suction at the inlets? What type of ducting system do you have for each?

Thank you Jim for providing that balanced viewpoint. You are right. They have been doing this for many years and their are many good reviews.
As an aside, I assume that your ducting is all 5” metal?...

What type of cyclone do you have Bill that you are able to modify it?

I was looking at Oneida’s Super Dust Deputy XL, the 6” version.on their website, they say “ ultra-high efficiency with integrated air ramp and 6" neutral-vane inlet”. I sent them an email just to...

I am a bit late to this conversation but I have one question. Do you run more than one tool at a time? If you only turn on one at a time, all of those tools could exist on the one 20 amp circuit....

I had a natural gas radiant tube heater for my 24x28x10’ ceiling garage in Edmonton, AB. Much colder than Ohio.
R22 in the walls, R40 in the ceiling.
I think you can get one for propane.
sure, it...

Darn, I gave away my water level 15 years ago when I bought a small cross hair laser level...

Thank you Jim. I may have to invest in a manometer...

Chris, did you ground your pvc? I have heard differing opinions.
Thanks, Aaron.

Thank you Frank.

Thank you for your reply Eric. I shall add that information into my design.

What dc system do you have Stevo?

Jim, you are pretty knowledgeable. Just in your opinion, I won’t hold you to anything, what is the minimum HP that could utilize 6” piping, with the Oneida SDD XL ? I have seen the video from Gray...

Steve, may I ask what type of setup you have? HP of dust collector? Cyclone? Feet of piping?

This is what you want...454198

I am upgrading my dust collection piping to 6”. Since it is just me, only one machine at a time will be running. From the 6” branch line, I will be putting drops to various machines, terminating in a...

I guess that was in the back of my mind.
if I can’t find a retailer for Unisaw, should I get it.
Sawstop is everywhere in Canada and it sounds like they have good service.
thanks to all for...

I have been searching online and I have yet to find a place in Canada that sells Unisaw.
Is it available?
i am sure I can go to a tool store and they will order one but I am surprised that there...