A couple thoughts,
Being a 1999 tube it very well might need to be recharged.
Could your power setting in the software be too low, maybe the laser is firing but the power is not high enough.
...
Type: Posts; User: Chris Achtschin; Keyword(s):
A couple thoughts,
Being a 1999 tube it very well might need to be recharged.
Could your power setting in the software be too low, maybe the laser is firing but the power is not high enough.
...
Thank you!
Thank you, I do have the Z touch plate, it works great.
I would be interested in ways to zero the xy.
I'm used to setting my 0 to the bottom left corner and moving the bit to that point of the...
I have a Next Wave Shark HD510.
I previously had a Xcarve 500x500 and used a Triquetra zeroing plate to zero the XY and Z. I also used Picsender to send the data to the Xcsarve. Does anyone know if...
Hi all. I have purchased a Next Wave Shark HD510 with a 2HP water cooled spindle.
If I push the pause button, during a carve on the pendant, the CNC stops but the water pump continues to run.
If...
Thanks for your help.
I've never tried the wipe on poly but I will pick some up and give it a try!
I am struggling finishing a wood plaque.
The plaque is 16 x 20" .75" thick.
I've got it stained successfully.
When applying Minwax polyurethane with a brush, I'm having issues with the poly...
Thank you very much Kev for the detailed instructions!
I just completed the replacement.
Thanks again!
Hi,
I have a New Hermes 3400 and need to replace the spindle belt (O Ring).
Does any one have any guidance on this procedure. I have received the replacement belt from Q1.
Thanks
I've used Evergreen twice with great results
Thanks Kev,
I think they are all in China, the shipping would make it cost prohibitive.
I've never been able to find the small grain (Mongolian Black) tile other than at Lasersketch.
I'd be interested if anyone knows a source.
There is a carrier which makes it easier to apply lasertape, after applying remove carrier and laser.
Rub and buff works good, also Lasersketch sell a white color fill that works great
JDS and MARCO Awards are trophy vendors/suppliers
I vote for the single forum:)
Ended up being 2 RF Transistors on the internal circuit board in the tube.
I'm back in business!
Thanks for your input!
Thanks Lee,
I dropped it off at Evergreen along with the power supply.
I hope to hear soon, I really think it's the tube.
Thanks Lee.
Tube is out of warranty, I had it recharged 15 months ago.
Sounds like the tube is pooped, I'll send it out to get reared/recharged, they will check it just in case it might be good. ...
I have a Versalaser VL-200 30 Watt laser.
I was lasering some bricks, ended the job, everything ended correctly.
I then went to a previous job on the driver and the problem starts:
With the door...
I wonder what a clear UV spray would do Kev?
Is your black fill is 100% black?
Hi Bill,
I just talked with them a little while ago
I have found medium hot water works better than chemicals.
I have the same problem with Blue/White.
ASI and/or PPAI are really for items that are already embellished. You can buy blanks from most suppliers but the pricing wont really be wholesale.
JDS, MARCO, and Laserbits are just a few options...