Search:

I can't figure out how to get a picture to post properly for some reason, but here is a link to what I have right now. http://www.jcsautomation.com/temp/dc.jpg

I actually have fairly decent flow...

Unfortunately, I'm probably stuck with the 4" setup for a while. If the Rikon impeller shows substantial gains for you, I may upgrade mine and run with it for a while. Anxious to hear your results...

Thanks for all the info Lane. I talked to Rikon today, and they said they would have impellers sometime mid-February. Not sure on the cost, but I've heard around $120 now (shipped). Being on a tight...

Did the Grizzly have to be machined to fit the HF shaft? The only other impeller I saw referenced required the hole to be opened up a little...but I don't remember if it was that Grizzly or not.
...

I haven't seen any hard numbers, but the general consensus seems to be a significant improvement once the proper impeller is installed.

Mainly because they are backordered until mid February...but it also wouldn't hurt to have some other alternatives; maybe even less expensive ones since Rikon apparently has the "HF impeller upgrade"...

All this interest and nary a reply. :)

How about this... does anyone have the specs of the Rikon impeller (shaft size, weight, exact diameter... any other pertinent info needed to source one...

I've seen the Rikon 60-200 impeller mentioned several times as an upgrade for the HF dust collector, but does anyone know which other impellers will fit without modification?

I would bet that...