Search:

or nm I will contact Trotec on how to adjust.

i'll try the wireframe view
Kevin how do I adjust the tickle issue. Is there a general term for it?

Hello I have run into a strange issue and can't figure out what it is.

If you look at the images there is a "lighter engraving" as if it laser engraved very lightly outside the artwork. this...

I just added images to my first post of the black stains on the table.
I'm not sure if it is actually mold now.

Hello

Last year I made tables out of birch plywood for a restaurant patio however some of the tables have deep black water stains.

I have sanded off the coating and tried oxide paste (bar...

Hi Tony, I am located in Montreal

The laserable aluminum that you mentioned are they black on both sides? The ones I have found are only black on one side and very thin.

They say they don't carry those products

thanks ! I will contact them !

382046
Hi everyone, 382047

Would anyone here happen to know where I can purchase anodized or laserable aluminum sheets. I need the sheet to be black and when laser engraved the artwork comes out...

Yes they might be used a few times every summer about a few days to a week for each event

Im leaning towards the varnish that I postednow deciding to use water or oil based
I would like to have...

I won't be staining them, just need to put a durable finish on it because they'll be cleaned often from rags / water etc. These are temporary tables used during a weekly event that happens a few...

Thank you for the suggestions everyone

Hello what would be an acceptable budget finish for a wooden table to be used outside a restaurant. They will be used for 1 week only and will be cleaned by waiters all day. A salesman told me I...

Hello everyone,

I have a project coming up to make an exterior sign for a restaurant. Im planning to make it either engraved and colorfilled on a wooden board or a 3d sign woth the letters cnc'd...

i realize I posted in the wrong forum, will make new post in the woodworking projects forums

We haven't spoken about the budget yet, I'm seeing if it's something I can do first. We have snow and ice here, afraid of damage from the ice / water expanding in the sign

Hello everyone,

I have a project coming up to make an exterior sign for a restaurant. Im planning to make it either engraved and colorfilled on a wooden board or a 3d sign woth the letters cnc'd...

ok so I won't take a chance with water based stains. How about oil based stains?

Hi everyone I am in need of advice
I have a project to make serving plates for a restaurant

Im using birch plywood and ill be staining them with Saman water based stains.

How do I make sure it...

Im using the standard lens that came witg the trotec. Not sure what it is but probably a 2.5

And yeah plexiglass for example i usually dont do one pass to go through
I go slow speed low power...

Ok so you guys are saying a software isn't necessary to laser cut for example a 3/8 thick plexiglass?

I understand it wont be as flat as machining it but as long as it doesn't come out slanted

I have also tried lowering the focus after each pass but the results are not very nice
It seems the edges on certain sides get "shifted" to another direction

Hi all I dont remember if ive ever asked this but is there a manual technique or free software to manipulate the laserachine to cut thick materials with a flat edge?

I have been told by...

Hi everyone

I'm looking for suppliers in Canada, preferably in Montreal that supply promotional products. Mostly bamboo / anodized aluminum stuff. I'd get them from China but I don't need huge...

Hehe looks like I'm too late, not able to reply post in that page

I was aware of Vectrix
On the Probotix page they suggested Artcam express for 149$ and meshcam I think it goes for around 200$...