I was just looking at the doing what you suggested but I will have to make the length adjustment at the lever end. The end of the shaft at the far end has a pined yolk connected to the clamp riser...
Type: Posts; User: David Olsen; Keyword(s):
I was just looking at the doing what you suggested but I will have to make the length adjustment at the lever end. The end of the shaft at the far end has a pined yolk connected to the clamp riser...
Have to ask, did you move the clamp on the far side of the table up inside the fence, so the face of the fence extends past the output side of the table, basically like it shows in the picture, but...
Just hoping to make it look like an original equipment setup.
Also, I am trying to go with the original designers way of doing this. I have found that when I try to re-engineer some part of a...
I guess if some one that has this aluminum Delta fence could help me with a measurement of table width on their table saw and a measurement of their fence, just to make sure we are on the same page. ...
I have a Delta table saw fence that I need to cut down to fit my 24-1/4" Rockwell 28-3X5 band saw table. I can wing it, but I have read of this being done before. I believe the table saw tables are...