Search:

I just wanted to give an update. I did a bunch of troubleshooting and test cutting on scrap. I think the issue was that my riving knife was slightly out of alignment. The back side opposite from the...

I found this 10% off coupon and was able to use it before buying my table saw: https://www.foureyesfurniture.com/grizzly/

It looks like it still works. It's only applicable to the equipment listed...

Thanks guys. That's what I was thinking. What was confusing was that the stock 40T blade did not have any burning. I even paused mid cut to adjust my push stick without causing any burning. What I'm...

I just recently started working with some 6/4 hard maple and am having some issues with burning on rip cuts. The burn marks are not along the whole edge, but just some areas. I checked the blade...

Just to give an update, I ended up discovering a major issue after I got everything up and running. My saw has a blade alignment problem. If you align the blade to the miter gauge slot, the alignment...

Thanks Bill, I appreciate it. I'm glad you're liking it. The good news is that I managed to finish enlarging the holes and now have the wings attached. I had to use some aluminum tape to shim both...

Wings, not the saw. The wings have a slightly larger hole than the bolts to give a small amount of adjustability. The saw holes are threaded for the bolt to go into.

Just to give an update, I received a call from tech support. I was on my way to the store and was going to drop the packages off to be shipped while I was out, so they got a hold of me just in time....

One hole on each side of the wings is off by 1/16th of an inch vs the others. It forces the wing to be too low to the table by that much on that side. It's off by just enough that you can't get the...

I received my saw, but unfortunately I'm not able to finish setting it up, due to a major problem with the extension wings. 1 out of the 3 holes on the sides of the wings was drilled slightly too...

Not having 220 in my basement shop was one of the main reasons I went with it. It seemed to be the best value for a 110v saw. I also did not want to deal with getting a heavier saw down into my...

I have one on order. They've been out of stock but are supposed to be coming in a few weeks. I'll let you know how it is once I'm able to test it out.