Ok, now?
Attachment 368501
Had to get out a "new" candle, wore the old out. After each groove was ploughed, decided to try something...different.
Attachment 368502
I ran the 60-1/2 along, to do a slight bevel, on both corners of the groove, Seems to help the raised panel sit in the groove better..
Attachment 368503
Got four rails done, now the fun part..
Attachment 368504
Had to make sure the outside part of the jig cleared the bottom of the fence on the Stanley #45, yet still helped to hold the stile in place. Marks from that screw will not be seen. Then a few swipes with the block plane, again. Finally got all 8 parts grooved
Attachment 368506
Was I done for the day? Nope, decided to try some tenons..
Attachment 368507
Laid out for a tenon, Mitre saw to cut the shoulder cuts..
Attachment 368509
Bandsaw to make the cheek cuts.....
Attachment 368510
Reset the mortise jig....and then called it an afternoon....lunchtime! Might meander back to the shop, later....and chop a few mortises...would like to get at least one end panel glued up
May have to work on a Monday, otherwise..:eek:....stay tuned