Maple Frame & Panel Box

Rather than throw out onto the fire pit...decided to try and make something out of a stack of Maple scraps....
Attachment 391375
Front panel is a book-match resaw, edge glued, and then planed into a raised panel
Attachment 391376
Same goes for the panel in the back. Panel for the lid was a 3 board glue up. Ends were some 3/8" thick Cherry scarps..
Attachment 391377
That just happened to be wide enough ( ran out of thin Maple..) Box stands 9" tall, counting the lid.
Attachment 391378
Chain to hold the lid....
Attachment 391379
Simple ( and SMALL) brass hinges. I tried to show off the grain.
Corner joints are Tongue & Groove glue joints.
Thanks for looking in...
Attachment 391380

I like it, and it's hand made unpretentious quality. The obvious "this wood is NOT going to be wasted" will make all future owners smile. Reminds me of an old ballot box.