Tom Yaegle
Contributor

Jerry, It is a nyloc nut. For the rest of you SCM shaper owners you may want to check for a grease cup. Fill cup with grease and tighten up now...

Warren, I could turn it over. It has a slider that would have to come off also. SUCCESS,It was a pain in the hiney. 3' bar to get loose, but it...

Thanks for ALL the ideas. My first attempt failed, it is 8pm and I quit for the day. I took a 2" socket and welded 3/16" key stock inside in 4...

Here is what I am looking at, It is right hand thread and 1.730 or so inside socket dimension.

Bill, I have the sockets for Fords. They are to big, will check auto part to see if there are smaller ones that may work. Jerry, This nut is up...

Trying to get the nut off holding the pulley. It is not a hex but round with 4 slots on it. Thinking I need to make a socket or has anyone found one...

Jim, I will try there. The T130 does not have a serial # tag on it but will try there with out the #s and see. Thanks

Jerry, I have not found a good parts break down with google? Jared, I read that but have not found any good info, just that they changed theirs.