Scott Memmer
Member

Thanks, Aaron. That would probably be fine. What about the top RPM with a Baldor? How high could you go? Thanks again. sm

I hear ya. I'm looked at those solutions and I've used and do have those blades -- like, 5" w 320 TPI. Still iffy. This solution is better, I think,...

Thanks for your post, Stephen. Please see my post immediately about describing the materials I'm using. Forgive my ignorance, but aren't electric...

I've looked at this option vaguely. Did you have a particular machine in mind? The problem is these plastics have widely varying melting points...

Bill, thanks. I'm in L.A. and there a BUNCH of used Baldors around me for very reasonable prices. Question, if I may. It appears most Baldor 3-phase...

As usual, you guys are full of the greatest ideas and options. I had no doubt you'd come through. To give a little more background (I was rushed...

Richard, thanks very much. Unfortunately, I have a very small shop and that would take up too much room. I guess I pretty much need a benchtop device...

Steve, thanks so much. I will check them out right now. sm