Hey Eric, Sorry it's taken me so long to get back to you. My wife had a medical emergency and it took awhile to get her out of the hospital and healed back up so I put this on the back burner! I appreciated you responding to my original request for some help. To jar your memory I needed some 1/8" or 3mm acrylic bent (180 degrees) to allow a sheet of 8.5x11" standard paper to slide into the folds which can be viewed from either side and slid into a C-channel bracket. I'll need 5 of them but lets do one of them and make sure it'll work and then we'll crank out the other 4. How about that? My address is Jim Good, 157 Foxfield Drive, Madison, Alabama 35758. I can pay thru Paypal or a credit card over the phone, or send you a check. Whichever is convenient for you. Also, I'm not real critical on how much material you leave around the border past the paper (outside the 8.5x11). 1/8" to 1/4" is probably fine. Let me know if you have any questions. Thanks! Jim
I have plastics shop in Oregon. Send me the dimensions of what you want.
