Lord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Bill Dufour Today, 4:09 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Nicholas Lawrence Today, 8:16 AMAccording to the book I'm reading (What If ? 2 by Randall Munroe) The second programmable computer, UNIVAC was the size of a room, made in 1951 from vacuum tubes. If the same machine was made from Iphone chips today, they could be imbedded in a single grain of salt.
Last Post By: Rich Engelhardt Today, 3:02 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Bill Dufour Today, 3:59 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Received it, tried it, didn’t work…I think. I need to play with it some more.
It came with 1 1” rod. I wonder if a different size rod would
I needed to move a 17” Rikon bandsaw from the garage to the basement once. Up three steps, through the laundry room, left turn, between the fridge and
Roger Feeley Today, 4:43 PMI have one that I don’t use. A coffin smoother. Purpleheart body and Lignum vitea sole believe.
Leigh Betsch Today, 4:42 PMI have that tool. Your setting is correct. 1.25 screws work for .5 material.
Use 1.5 screws for .75 material
Brad - you have to kick in a nominal $6/year & become a "contributor" to see pix on the site.
It's up in the control panel at the
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Today, 4:32 PM