I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jim Becker Today, 11:08 AMHi, I'm new to the forum. I'm 78 and have been using a Craftsman 10 inch 113.298051 for the last 39 years to build furniture for my house and various projects. I never upgraded until now because the craftsman could do what I needed and I didn't want to spend the money. Last week the fence wouldn't...
Last Post By: Terry Therneau Yesterday, 8:38 PMThis will be a "build" thread with a bit more detail than I've been doing lately, but it's an interesting project. Some might find it useful; some might scoff. :) But I just can't wait until the end to start posting because it would be too much to post all at once. -------- For background, our...
Last Post By: Jim Becker Today, 11:05 AMI've seen threads discussing the pros and cons of straight-sided versus bevel-sided mortise chisels. The big takeaways seem to be 1. Straight sides encourage a straight mortise with less chance of side-to-side wander 2. Chisels with angled sides are easier to extract after a chop and aren't so...
Last Post By: Cameron Wood Yesterday, 9:01 PMA while back, a friend gave me some reclaimed teak. Around here teak sells for almost $50/bd ft so it was a welcome gift. I made a few small things out of it but eventually built some jewelry boxes from the teak and some olivewood that I had. I didn't have a lot of teak left but decided to do...
Last Post By: Mike Henderson Yesterday, 11:05 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
That's strange. If the wiring diagram is correct, the power cord should go to L1 and L2. L3 connects the red wire from the motor to L1 when it latches.
John TenEyck Today, 11:27 AMMy point was that if they claim "low alloy steel" and if it is a Cr-V steel, that is not inspiring.
Then pointed out that some Cr-V steels
That looks like it's for a 3 phase unit.
John
Maurice, I have a diff lock on my Kubota BX22 with HST and yea, it kicks things into a different level when you need that...like when I was removing 30
Jim Becker Today, 11:08 AMOn the drawer slides...cost because I had them "in inventory".
The ash for the drawers will be reflected later in the project so
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 11:00 AM