My router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Cameron Wood Today, 3:00 PMHow is the Margin Of Error determined for a survey? I don't care who does the survey or what it's for I'm just curious how the margin is determined and who determines it.
Last Post By: Jim Koepke Today, 2:00 AMBeen watching Matteo for years and now many top players are recognizing him. I think hes 24 now. Video is not great and sound not great but I can hear whats going on. Very nice of Joe to bring him up and others that are spending time with him. Hes innovative. Very unique finger picking style....
Last Post By: Maurice Mcmurry Yesterday, 8:44 PMI'm pondering the economics of a mill vs buying rough lumber at retail/wholesale. In the Bay Area, depending on where you shop hardwoods like Oak and walnut can run up to $15-18bf/ft, or more for the rift/quarter sawn stuff. If one is able to source your own logs, running your own mil and kiln...
Last Post By: Maurice Mcmurry Yesterday, 7:06 PMI'm down to 2 routers and need a couple more. I have read the 690's aren't what they used to be. Suggestions?
Last Post By: Earl McLain Today, 1:20 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
It's kind of a PIA, but it is often possible to disassemble the switch and clean it. What usually happens is dust gets in and sticks to the grease on
Cameron Wood Today, 3:00 PMTop needed a second coat..( seen on the way back upstairs, BTW)
And a corner view of the left side..
And the "Full
I have two, 20 lb propane bottles.
I received a reply from Ooni. The only thing that stood out was the recommendation to leave the door
All editing done in-house...HP Pavilion, running Windows 10..
Corner view?
Sounds like you have a plan, but just in case.... You might take a look at buffalo grass; one of several types native to the high plain's short-grass
Malcolm McLeod Today, 2:35 PM
Help with low motor power on table saw
Thread Starter: Karl CardHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Tony Shea Yesterday, 5:28 PM