Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Nicholas Lawrence Today, 8:16 AMAccording to the book I'm reading (What If ? 2 by Randall Munroe) The second programmable computer, UNIVAC was the size of a room, made in 1951 from vacuum tubes. If the same machine was made from Iphone chips today, they could be imbedded in a single grain of salt.
Last Post By: Doug Garson Today, 1:11 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Jimmy Harris Today, 11:38 AMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
I received a shipment from Harvey and also included was a very nice aluminum zero clearance insert. I emailed them, explained i had an extra part in
Patrick McCarthy Today, 2:20 PMBack in US, I used to buy a lot from Zoro. And, they always have one or other promotions going on. Practically all my Mitutoyo rules and pipe clamps were
Anuj Prateek Today, 2:12 PMMatteo is obviously very talented, as is Joe, I never really paid much attention to Joe, but seem to have warmed up to him a lot lately, he seems like
Mark Hennebury Today, 1:53 PMHard to say. Is it RF? IR? Did the old batteries leak? If so, the battery acid can corrode the terminals and make the new batteries not work. If
Jimmy Harris Today, 1:43 PM
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Bill Dufour Today, 11:34 AM