Lord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Brian Elfert Yesterday, 3:21 PMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: Jim Becker Today, 9:59 AMHey All, I was going to build that "Knock Down Nicholson" bench in Chris Schwarz' workbench book this weekend. Question. He recommends getting your big box lumber, whatever it is, and letting it acclimatize and reach equilibrium in your shop before building. Totally makes sense, but I kinda want...
Last Post By: Ron Citerone Today, 8:46 AMSo our old microwave a GE bit the dust, was perhaps 20 years old. Purchased a new one and instructions said needs to be 13 inch deep cupboard at the most, and duh the door now hits. Never did on the old as it was a different door design. GE wants $75, Home Depot $130 eBay $75 but with free...
Last Post By: Jim Becker Today, 10:06 AMAccording to the book I'm reading (What If ? 2 by Randall Munroe) The second programmable computer, UNIVAC was the size of a room, made in 1951 from vacuum tubes. If the same machine was made from Iphone chips today, they could be imbedded in a single grain of salt.
Last Post By: Warren Lake Yesterday, 11:54 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Here's a picture of the little bird bath that will sit on the table pictured. Much nicer than the cinder blocks. Will sit @ 4" higher. Thanks.
Brian Runau Today, 10:31 AMI like Joe’s setup there! I’ve got some flush trimming to do next week and I’ll give that a go on my shaper. I’ve been using a
John Pendery Today, 10:27 AMBoth my maple and birch trees have been prolific seed makers this spring. It looked like snow falling under my birch for a couple days.
that's all very good info, thanks. i thought about the shaper... i have the same cutter head that joe uses, and theoretically i should be able to set
David Zaret Today, 10:21 AMWhat is the shape and size of the building, and type foundation? I've built a lot of new buildings over the decades that I was doing that for a living,
Tom M King Today, 10:16 AM
California bans the SALE of gas lawn mowers and leaf blowers after 2024
Thread Starter: Bill DufourSaw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Pat Germain Yesterday, 11:41 PM