About a month ago I began a thread about designing and building two carver chairs to accompany the 6 bentwood chairs we have owned for the past 40 years. The chairs were purchased all those years ago along with a table, which is around 200 years old. We need a larger table, and time has come to...
Last Post By: stephen thomas Today, 3:07 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 12:56 PMOne of those sitting at the computer in the morning with a cup of coffee itching to buy a new tool ... So I come across this Veritas Scraper Burnisher for Turners and looked at a few videos reviews of it and thought why not. After reading a few reviews posted on this forum I later realized it was...
Last Post By: stephen thomas Today, 1:46 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Dan Friedrichs Today, 5:12 PMMy router on the recently purchased router table quit, it came on then off then on now it will not come on. I have it pulled apart trying to get all the sawdust out of the connections, it's embedded pretty bad, not sure if that is the cause but worth a try. I found another identical one on eBay for...
Last Post By: Rich Engelhardt Today, 11:32 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Here’s what Chat GPT says. https://chatgpt.com/share/438f83d7-4...1-aa324f7bc8c2
Michael Weber Today, 5:47 PMWow, that it is!
Even if it is a center match. (bookmatch/2pcs)
I'm not exactly a luthier, though it do hang out on some sites ......
Jonathan,
I can vouch for Oneida's design service. They did a very nice job on my shop design when I changed over my dust collector, suggesting
The harder you press, the more aggressive the Arkansas stone. The abrasive action of the stone can be felt through your fingers by varying the degree
Rafael Herrera Today, 5:37 PMjim thank you so much
what you think of these?
https://www.dictum.com/en/shaping-st...ne-fine-711052
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 7:57 PM