Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Jim Becker Today, 9:50 AMSaw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall. It will probably take ten to twenty years until this ban goes...
Last Post By: Patty Hann Today, 9:30 PMLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Jim Becker Today, 3:36 PMHas been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Today, 10:21 PMI'm looking at moving my shop soon, up to 45 minutes away, and am faced with a couple decisions. Thanks for being a sounding board. I'll want a forklift eventually, out of convenience not necessity for daily operations, and am wondering if the move is bringing a large enough reason to justify...
Last Post By: Jonathan Jung Today, 7:01 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
Somehow, I don't think that Union #41 can cut a 1/2" deep tongue...we'll see how things go...Can always come back and deepen them if need be..
steven c newman Today, 10:24 PMThat router bit was bought at Harbor Freight this morning, along with a 30" F style clamp ( now have a pair!) and a pack of three 80 grit sanding
steven c newman Today, 10:21 PMI have one. I think it says 40-70psi and it sounds and seems slower at 40psi. I think if you go lower than that it gets slower but then it just might
Jim McCue Today, 10:17 PMDecided to cut 2 blanks for length over on the Langdon 72c...then joint the edges a bit..
And get them ready to plough a groove...
Trying to "walk it off"...clamps came off the panel for the Top..need to square the ends...
Guide for the Vintage Skil Home Shop
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Today, 6:48 PM