For the size of this shop for distances and drops, I strongly suspect that the current DC is potentially inadequate as the 6" inlet absolutely limits...
A compression bit will work, but they are generally designed for situations where one needs to have pristine cut lines on both top and bottom. There...
No personal experience or knowledge of it. I did a search and on router forums (old thread) it was discussed and generally seemed to be well thought...
1) Accurate polling is a very difficult and expensive proposition. The primary issue is ensuring that the sample is representative, as many have said...
Personally, I release most, but not all the tension. Two reasons. The wood could be bent permanently if under constant tension. Also, how do you know...
I have a Home Center Ridgid Table Saw with a 3HP 1PH motor I wired for 230V. It spins up quick and will muscle through about anything I throw at it....
Jim, the 10.8v C12 has been a delightful drill/driver for many years. Lighter than anything else I had. Its lower power was only evident when I used...